Niagara 7000 Internal

Low-Z Power | Noise-Dissipation System

Redefining the Science of Power Conditioning

AudioQuest Niagara 7000 Internal


  • High Current - AC Outlets (Schuko-EU, UK-13, NEMA-Edison type available)
    (4 outlets – 3 for UK model – power ampliers, powered subwoofers, powered speakers)

  • Source Component - AC Outlets (8 outlets – analog – digital - video)
    6 isolated AC power outlet banks with 16 amp RMS average (@220-240VAC 50/60Hz) current capacity (high current), and 2 source outlet banks of 4 outlets each, with 3 amps total capacity per group. These outlets utilize high spring-strength beryllium copper base metal with heavy silver-plated contacts. This assures far lower loss and distortion, while providing a superior means of draining radio frequency noise.

  • Ultra-Linear Dierential / Common-Mode Filter – Non-Sacrificial Surge Suppressor
    Over a third of low-level audio/video resolution can be masked or lost to induced radio frequency and AC noise. The Niagara filters are optimized for real-world impedance and cover an unprecedented range of over 21 octaves. Non-sacrificial surge protection and auto over-voltage shutdown mean that your components will be protected, AND the Niagara will also protect itself. Set and forget level protection.

  • Transient Power Correction
    From nimble, efficient Class-D to mammoth Class-A mono block power amplifiers, average (RMS) current draw can be modest (2 to 7 amps). However, wide dynamic range audio content can create very fast transient current demands…. as much as ten times that average. Our correction circuit bolsters and stabilizes the power supply of any power amplifier by providing a buffer and an instant current reservoir of up to 80 amps peak (20mS).

  • Ground Noise-Dissipation System (patent #8,988,168)
    signals. This is critical as the AC ground is directly connected to component circuit ground. Employed in concert withour Ultra-Linear filters and direction oriented, grain-controlled AudioQuest AC cables, this ensures the highest resolution and lowest distortion performance from your system components.

  • Two Discrete Symmetrical AC Power Isolation Transformers (not shown)
    These massive transformers provide 100% isolation from the middle four AC source outlets, from the middle four source AC outlets and the high current AC outlets. Additionally, symmetrical induced noise (common-mode) is reduced to the lowest level possible, over the widest range of frequencies possible.

  • Dielectric-Bias Transformer Supply (patent #'s 7,126,055 & 7,872,195 B1)
    By electrostatically charging the insulation materials in the isolation transformers, the efficiency and linearity (consistency) of the filter is greatly improved. This technology provides greater clarity for connected system components by greatly reducing noise masking and distortion. This is particularly critical at the highest frequencies where ordinary isolation transformers will fail.